VS - Electrical Systems From Stop-Start to Hybridization

The ReStART machine The ReStart machine is composed of:

Reinforced solenoid switch (springs, contact rod)

Dual contact switch

●● A long commutator bar ●● 6 to 8 long life brushes (20mm height)

Increased number of teeth/tooth design for ring gear

Long life Rear part : 8 brushes

●● 3 needle bearings stages ●● Intermediate flange with needle bearings ●● Ring gear with damper ●● Clip on the axle to minimize the axial motion ●● 6 magnets yoke without shunt for better commutation effect

l Reinforced solenoid with dual contact switch l New tooth design with increased amount of teeth

Needle bearing

Strengthened reducer ring with shock absorbers + improvement of shaft guidance and centering

Needle bearing

6 brushes with 20mm height + needle bearing

Ring gear with damper

Long commutator bar

Arm stop by clip to minimize axial movement

Intermediate flange with needle bearing

6 magnets yoke without shunt for better commutation effect

ESM - Permanent magnet inductor machines

50